What should I do if the pressure in the test chamber compressor is insufficient?

First of all, it is necessary to check whether the equipment is obviously abnormal. In the event of a failure, the fault is first eliminated from the machine itself. For example, whether there are parts lacking lubricants. Looking at the recent maintenance and repair records may help you quickly find the problem.

Second, it should be recognized whether the amount of gas used at the factory suddenly increases. Is there any leakage in the post-treatment pipeline? When this happens, it must first be checked from the periphery. From the outside to the inside, there is a simple to complex check of the components.

In addition, check whether the internal piping of the compressor in the low-temperature constant-humidity test chamber is unblocked and whether there is any blockage. Check air filter, belt, pressure sensor, piston, unload solenoid valve, inverse proportional volume control valve, etc. are in good condition. The integrity of the control line, as well as the release of the solenoid valve diaphragm.

All these situations are encountered, and you can judge according to different failure reactions. Just remember to avoid confusion when problems are encountered, and solving problems in a gradual manner is feasible.